|
| Wire problems in an irrigation system can be time-consuming, pain staking, and expensive. This is why we’ve developed these three products. No more hand watering, no more digging around in valve boxes reconnecting wires, no more trenching in new wires, no more tracing wires for days with rented wire tacking equipment. Use one of our three easy to understand, reasonably priced products and have your system up and running in a few hours. One of these three products should take care of any wire situation you may have. |
|
|
Easy Switch |
| The Easy Switch is a simple cost effective flip-flop device that will run up to four valves on one good wire. No Batteries required! This unit receives all it's power from you main controller. After each power on-off event the Easy Switch will switch and water the next valve. |
|
|
Easy Switch Instructions PDF
|
|
|
|
|
|
Switcher |
| The Switcher is a simple direct burial timer that will run up to four valves. This unit is basically a small timer that works great for adding valves to an existing system. Each station on the Switcher can be independently timed from 0 – 30 minutes in two-minute increments. This unit is completely water proof and is designed to be mounted in a valve box. |
|
|
Switcher Instructions PDF
|
|
|
|
|
|
Quick Link |
| The Quick Link is a two-wire unit that can be installed in any controller. This unit is great for bypassing broken wires. You install the transmitter in your main controller and the receiver in the valve box and you can control up to four valves as though you never had any broken wires. |
|
|
Quick Link Instructions PDF
|
|
|
|
|
